Installing Alternate Ac Plug On The Battery Charger; Calibration Gas Supplier - Dräger Multi-PID 2 User Manual

Appendices

Installing Alternate AC Plug on the Battery Charger

In most cases the Multi-PID 2 will be shipped with an AC line cord
that will fit the AC wall outlet in your area. If this cannot be done, you
may need to obtain an AC line cord suitable for the AC receptacle in
your area.
The AC line cord, attached plug and receptacle must be marked with
your country's certification mark and the cord must have a Harmoniza-
tion (HAR) mark.
The line cord must be rated for either 100 to 120 VAC at 60 Hz or
220 to 240 VAC at 50 Hz. The voltage rating will depend on the
voltage in your area.
Contact your Dräger Safety representative to obtain more information.

Calibration Gas Supplier

The recommended span gas is isobutylene in air. 100 ppm isobuty-
lene in air may be obtained from Dräger Safety.
The exact concentration will be determined by your application. Other
concentrations and other gases may be obtained from your local gas
supplier. If you cannot locate a local gas supplier, contact Dräger
Safety's Technical Support Department.
96