Table of Contents
Advertisement
3.3 Sampler installation
3.3.1 Sampler type
1
ASX-500 Autosampler
3.3.2 Unpack the ASX sampler
The QuikChem 8500 Series 2 can be used with either the ASX-500 Series Sampler or
the ASX-400 Series Sampler
Figure 19 Autosamplers
Note: If any of these items are missing or damaged, contact the manufacturer or sales
representative immediately. Ship the instruments returned for service in the original packaging
material to protect against damage during transportation.
ASX samplers are shipped with:
•
Sample tray(s), assembled and installed
•
Probe tube in styrofoam container
•
Tubing kit with waste line, sample line and probe
To unpack the sampler:
1. Remove the sampler from the shipping carton and protective plastic and place on the
laboratory bench.
2. Remove the probe arm from the styrofoam container and lay carefully on top of the
sample racks.
3. Open the tubing kit and identify the components required for fluidic connections.
(Figure
19). Installation is the same for both samplers.
2
ASX-400 Autosampler
Installation
21
Advertisement
Table of Contents
Troubleshooting
