Instrumentation - Regal 2000 ES Owner's Manual

INSTRUMENTATION

e helm station is equipped with a complete set of instruments
that allows you to monitor the condition of the engine. Close
observation of the gauges may save the engine from damage. Gauges
do however have some inaccuracy, so do not rely upon them fully.
e dash ignition panel is protected by a amain 20 amp ignition
breaker located next to the key switch on the panel. It is connected
through the ignition switch. Your dash instrumentation (gauges,
displays, etc.) are protected by a 10 amp fuse underneath the dash.
Should this fuse "blow", investigate the cause before replacing it.
Also located on your ignition panel is a 12 volt accessory plug that
ts many portable electronic chargers meant for a cigarette plug.
Note that with the battery switch in the "o " position, there is no
power to the dashboard, and the ignition switch will not function
properly.
All electrical features are protected by a 50 amp main breaker
mounted close to the battery switch. A fuse for the stereo memory
and the automatic bilge pump system are also located next to the
battery switch in the engine compartment. Fuses for the engine
may be located either in-line, between components, or in a fuse box.
A separate 40 amp breaker protects the optional stereo performance
package and is located next to the battery switch. All the switches
on the dashboard also have a fuse, located in the forward starboard
storage area directly in front of the helm. Should a fuse "blow" it is
rst necessary to gure out the reason and address the cause.
Engine & Controls
3-23