Baudoulin 4M11G Maintenance Manual page 80

Maintenance M Manual of 4M1
⑦ After t the adjustm ment and alig
and oi il-free cams
the ca mshaft. Pre
and th en pre-tight
gear. T Tighten the
M10 b bolts and 55
seal pa aint.
Turn the cran T
1 Series Diesel l Engine For La
Fuel inject
Camshaf
Interm mediate gear
Engine oil l pump gear
Figure 4-3 9 Diagram fo
gnment of n
shaft gear b bolts, insert
e-tighten the e fastening
ten the conn necting bolt
gear conne cting bolts
5~60N.m fo or M8 bolts
nkshaft and d check the z
and Power Gene erators
tion pump
ft timing gear
Crankshaft gear
or Alignment of Gear Train
non-symme etric holes,
the bolts th hrough flan
bolts of ca amshaft tim
t between ca amshaft tim
by a torque e wrench. Ti
s. After the required tig
zero-points of all gears
72
Air compressor drive g A gear
Air compr ressor gear
n Markings
apply seala ant KB277 t
nge hole, an nd assemble
ming gear by y a pneuma
ming gear an nd air compr
ightening to orque is 85~
ghtening to orque is met
s for normal l engagemen
to the clean n
e them into o
atic wrench h
ressor drive e
~90N.m for r
t, apply the e
nt.