Accessory Installation - Ransburg 19372 Service Manual

W A R N I N G
!
† Replacing the plastic set screw with one
of conductive material (metal) will cause a
hazardous condition to exist, capable of pro-
ducing an electrical discharge possible of
sparking a fire. In all cases use the plastic
screw provided or provided as a spare part.
INSTALLING BELL ON SHAFT
(Figure 7)
Item #
1
No. 2 Motor Shaft
2 Shaft Locating Flat
3
Bell Set Screw
4 Bell
4. Re-position the feed tube in the bell cavity at
approximately the 4 to 5 o'clock position. The
feed tube should NOT rub on the bell. Adjust the
feed tube if necessary, by rotating it or sliding it
forward or backward in the barrel.
† The bell and feed tube MUST be
matched to ensure proper fluid feed into
the bell cavity. The following chart will as-
sist in selecting the proper bell and feed
tube combination:
AH-13-01.3
No. 2 Process Electric Motor Version - INSTALLATION
Figure 7: Installing Bell
on Shaft
Description
NOTE

ACCESSORY INSTALLATION

Included with the unit are two accessory items:
• Bell cleaning can and the gun holder.
W A R N I N G
!
† Insure ground line of the bell cleaning can
is attached to true earth ground when either
solvent is stored in the can or the can in use.
The Bell Cleaning Can provides a convenient and
portable method of removing excess materials
from the bell cup at the conclusion of spray.
C A U T I O N
!
† Insure any cleaning solvent used meets
criteria listed in the maintenance section of
this manual.
The gun holder provides a method to mount and
store the applicator when not in use.
Gun Holder 3936
Figure 8: Bell Cleaning Can and Gun Holder
BELL CLEANING CAN GUN
HOLDER
(Figure 8)
Feed Tube #
Bell Size
2 3/4 " 6335-00
4"
3700-00
6"
4076-00
Bell Cup Cleaning
Can 5170
Position of Tube
@2 o'clock
@4-5 o'clock
@4-5 o'clock
13