Fluid Filter Removal - Ransburg 19372 Service Manual

1
Figure 15: Fluid Filter Removal

FLUID FILTER REMOVAL

Item #
1
Fluid Hose
2
Fluid Filter
3
Fluid Inlet Fitting
Figure 16: Fluid Filter Replacement
FLUID FILTER REPACEMENT
(Figure 16)
Item #
Filter Front Housing
1
Filter Rear Housing
2
Paint Filter Element
3
AH-13-01.3
No. 2 Process Electric Motor Version - MAINTENANCE
3
2
(Figure 15)
Description
1
2
3
Description
1. Secure the rear housing of the filter assembly
in a vise and with a 3/4-inch wrench connected
to the front housing, remove the front housing
(right hand threads).
2. Remove the paint filter element from the rear
housing .
3. If a new paint filter is to be installed, clean
the front housing and rear housing using the
appropriate solvent .
4. If the same paint filter is to used, wash the
paint filter, front housing, and rear housing
in solvent. Use a bristle brush to clean paint
from the metal disk of the paint filter.
5. Secure the rear housing in a vise. Place the
paint filter element into the rear housing metal
disk first.
6. Turn the front housing onto the rear housing).
With a 3/4-inch open end wrench, tighten the
front housing to the rear housing.
7. Connect the filter assembly to the applicator as-
sembly and the fluid hose to the filter assembly.
26