Ransburg 19372 Service Manual page 36

Needle Packing Replacement
1. Complete steps 1 and 2 under "Needle Assem-
bly Replacement" in the "Maintenance" section.
2. Mount an 8 mm (5/16-inch) drill bit vertically in
a vise.
C A U T I O N
!
† Scoring or chewing of the metal packing
seat in handle may cause permanent dam-
age, requiring handle replacement.
3. Place the handle opening over the drill bit tip
and insert until the bit tip contacts packing.
4. Rotate the handle assembly until the drill bit
bites into the packing. Lift the handle assembly
(to withdraw the packing). Make sure all bits
of old packing are removed. Wash housing
with solvent.
1
Figure 21: Needle Packing Assembly
AH-13-01.3
No. 2 Process Electric Motor Version - MAINTENANCE
2
3
NEEDLE PACKING ASSEMBLY
(Figure 21)
Item #
Handle Assembly
1
Needle Assembly
2
Needle Packing
3
5. Place the new packing (Item 52) on the needle
assembly (see Figure 21).
6. To install the needle assembly, with needle
packing, refer to steps 4 through 6 under
"Needle Assembly Replacement" in the "Main-
tenance" section.
Description
32