Operation; Procedures - Ransburg 19372 Service Manual

OPERATION

PROCEDURES

Prior to operating the No. 2 Handgun, ensure that
the equipment is installed properly (see "Instal-
lation" section of this service manual). Observe
and follow the safety requirements at ALL times.
1. Inspect the rotating bell assembly to ensure that
it is clean and is not chipped. Replace or clean
the bell assembly when necessary.
2. Set the paint fluid pressure at 0.2 to 0.3 bar (3
to 4 psi ). Adjust the pressure up or down for the
desired fluid delivery. Higher fluid pressure may
be needed with higher viscosity material, longer
hoses, or higher fluid deliveries.
3. Insure the "ON-OFF" switch is in the off position.
(See figure 11)
Figure 11: "ON - OFF" Switch Location
ON - OFF SWITCH LOCATION
(Figure 11)
Item #
1
"ON - OFF" Switch
AH-13-01.3
No. 2 Process Electric Motor Version - OPERATION
Description
4. Turn the 9060 power "ON-OFF" switch on the
front panel to the "ON" position as shown in Fig-
ure 12. The unit will power up, but high voltage
will not be on at this point. because the voltage
is interlocked to the electric motor through the
"ON-OFF" switch on the applicator.
Figure 12: 9060 Power "ON-OFF" Switch
9060 POWER "ON - OFF"
SWITCH
(Figure 12)
Item #
1
Power "ON - OFF" Switch
2
HV on Indicator
5. Actuate the "ON-OFF" switch push the post to
the "ON" position. The electric motor will begin
turning and voltage will be present at the bell.
The HV On indicator on the 9060 will illuminate
when voltage is on.
6. Hold the No. 2 handgun perpendicular to, and
13 to 18 cm (4 to 7 inches ) from the part being
coated. Trigger the handgun and observe the
atomization of the coating material.
C A U T I O N
!
† The application process works best
when the bell is positioned perpendicular to
the grounded target. Following this method
avoids paint wrap back onto the operator or
nearby objects.
Description
16