Table of Contents
Advertisement
Figure 5: Fluid Fitting Assembly Procedure
FLUID FITTING ASSEMBLY
PROCEDURE
Item #
1
4.5 mm (3/16") Hex Key
2
Stem
3
Ferrule
4
Hose, Fluid
FLUID FITTING INSTALLATION
PROCEDURE
1. Lubricate all fittings with dielectric grease.
2. Screw ferrule (item 3) counterclockwise onto
hose (item 4) until it bottoms, then back it off ap-
proximately 3.2 mm (1/8").
3. Install nut over union stem and start the stem
into the hose.
4. Using a 4.5 mm hex key (3/16-inch ), screw
the union stem into the hose until it bottoms
against the ferrule.
AH-13-01.3
No. 2 Process Electric Motor Version - INSTALLATION
(Figure 5)
Description
INSTALLATION FEED TUBE,
BELL, BRUSH
1. Install the proper feed tube into the opening in
the applicator. See figure 6. Position the tube at
approximately as shown in the figure.
2. Insert the 3695-00 (item 2) brush into the bar-
rel. Position it as shown in figure 6.
3. Install the bell over the shaft. Hold the shaft of
the applicator and rotate the bell onto the shaft
until the bell is completely seated. Align the set
screw and the flat on the shaft. Tighten the set
screw at the bell hub hand tight. (Refer to Figure 7)
Figure 6: Initial Position of Feed Tube and Brush
INITIAL POSITION OF FEED
TUBE AND BRUSH
Item #
1
Feed Tube 3700-00 for 4" Bell
Feed Tube 6335-00 for 2 3/4" Bell
Feed Tube 4076-00 for 6" Bell
2
3695-00 Brush
(Figure 6)
Description
12
Advertisement
Table of Contents
