Front Panel - Shinybow USA SB-3888 Instruction Manual

FRONT PANEL

FRONT PANEL
1. POWER SWITCH:
The power switch turns the unit on and off. The LED will illuminate blue to indicate that the switcher is ON and
is receiving power. The switcher will remember that last state during a power cycle. When power is removed and resorted, the last
configuration will be evoked.
2. STATUS DISPLAY:
Front panel status display shows the current 9x2 matrix routing configuration. This same display also shows the
particular configuration settings depending on your current function. In run mode (as shown above), the display shows each Output
(destination) Channel and which Input (source) it is assigned.
3. FIVE KEY CIRCULAR BUTTONS:
4. IR SENSOR:
The IR sensor receives IR commands from the supplied remote control or third party IR emitter.
5. INPUT STATUS DISPLAY:
Input sources 1 to 9 LED illuminates blue to indicate that a video source is present on that input.
6. DESTINATION SELECT BUTTONS:
7. SOURCE SELECT BUTTONS:
Separate inputs 1 thru 9 select buttons are provided each source selection.
Input-01 : Video (Composite)
Input-02 : YUV (YPBPR)
Input-03 : VGA1
8. OUTPUT-1 & OUTPUT-2 VOLUME ADJUST BUTTONS:
selection.
9. 19 INCH EAR MOUNT PAIR:
Converts to a 19 inch rack mount. Bracket (part number: 1U-440L) INCLUDED. (Image shows rack mount
bracket attached.)
Press the Circular button to select Output #1 & #2 or other function modes.
Separate Inputs 1 thru 2 select buttons are provided each destination selection.
Input-04 : VGA2
Input-05 : SDI
Input-06 : HD1 (HDMI-1)
Separate 1 thru 2 Audio volume adjust control buttons are provided each output
Input-07 : HD2 (HDMI-2)
Input-08 : HD3 (HDMI-3)
Input-09 : HD4 (HDMI-4)
4