Front Panel - Shinybow USA SB-3879 Instruction Manual

7x2 (mirrored) multi format hdmi video scaler selector switch 7 in's converted to vga & hdmi output

Hide thumbs Also See for SB-3879:

Table of Contents

FRONT PANEL

1. POWER ON SWITCH:

The power switch turns the unit on and off. The LED will illuminate blue to indicate the switcher is ON and receiving

power. The scaler will remember the last setting during a power cycle. When turned on again, it will automatically apply the setting last

used.

2. MENU:

Press menu to open the On-Screen Display interface. Press again to exit menu. To Lock/Unlock the front panel, press and hold

the MENU button for 5 seconds to toggle modes.

3. ENTER:

Press enter to confirm your entries.

4. ARROW KEYS:

Use the arrow keys to move between the On-Screen Display options. Press the up key to enter the upper layer and the

down key to enter the next layer. Press the left and right keys to select options in the same layer or change the value of a parameter.

5. IR SENSOR:

The IR sensor receives IR commands from the supplied remote controller or a third party IR remitter.

6. OUTPUT SELECT BUTTONS:

Select the desired resolution supported by your display devices. Press OTHERS for resolutions other than

XGA, WXGA, 720p, 1080p. The button will illuminate blue to indicate it is selected. Advanced resolution adjustment can be found in the

OSD options.

7. INPUT SELECT BUTTONS:

Select from one of the (7) video signal buttons you intend to be scaled. The button will illuminate blue to indicate

it is selected.

Table of Contents