Advertisement
FRONT & BACK PANEL - INPUTS/OUTPUTS
FRONT PANEL
1. VGA INPUT:
Connects a VGA (RGBHV) signal source to the VGA
connector.
2. AUDIO INPUT:
Connects the stereo audio output port of your source
audio device to the stereo audio (AR/AL) inputs.
3. DC POWER INLET / OUTLET:
The converter suits a DC power plug-
pack input connector. Please ensure the plug-pack used is of an
approved type and of correct current, voltage output, and connector
polarity. DV 12 Volt, power supply 1.25A.
4. POWER LED:
The power switch turns the unit on and off. The
LED will illuminate red to indicate that the switcher is ON and is
receiving power. The Switcher will remember that last state during
a power cycle. When the power is removed and resorted, the last
configuration will be evoked.
5. HDMI OUTPUT:
Connects a HDMI direct digital video/audio
signal link to the female HDMI connector, which supports HDMI
digital video/audio and DVI digital video sources. If you remove
the HDMI screw posts, you must use the provided HDMI Locking
Post replacement screws to keep the internal HDMI jack secure.
Removing the HDMI screws without installing the HDMI Locking
Post replacement screws will void your warranty.
BACK PANEL
VGA (RGBHV):
Note: With D-SUB-HD15P female socket.
STEREO AUDIO (AR/AL):
phone jack connector.
Note: Female phone jack for each channel.
POWER JACK:
DC Jack: Inner OD Ø 2.1mm (+)
Power Input: 12VDC, 1.25A
HDMI CONNECTOR:
Note: With proper adapters, the scaler can
be used with DVI digital video signals.
3
HD-15P female socket.
Via OD3.5mm ear
Outside OD Ø 5.5mm (GND)
HDMI female connetor
Advertisement
