Front Panel - Shinybow USA SB-3693 Instruction Manual

FRONT PANEL

FRONT PANEL
1. POWER SWITCH:
The power switch turns the unit on and off. The LED will illuminate blue to indicate that the switcher is ON and
is receiving power. The switcher will remember that last state during a power cycle. When power is removed and resorted, the last
configuration will be evoked.
2. STATUS DISPLAY:
The front panel status display shows the current matrix routing configuration. This same display also shows the
particular configuration settings depending on your current function. In run mode (as shown above), the display shows each Output
(destination) Channel and which Input (source) is assigned.
3. FIVE KEY CIRCULAR BUTTONS:
Press the Circular button to select Output #1 & #2 or other function modes.
4. IR SENSOR:
The IR sensor receives IR commands from the supplied remote control or third party IR emitter.
5. INPUT STATUS DISPLAY:
Input sources 1 to 8 LEDs illuminate blue to indicate that a video source is present on that input.
6. SOURCE SELECT BUTTONS:
Separate Input 1 thru 8 select buttons are provided for each source selection.
7. 19 INCH EAR MOUNT PAIR:
Converts to a 19 inch rack mount. Bracket (part number: 1U-440L) INCLUDED. (Image shows rack mount
bracket attached.)
4