Advertisement
FRONT & BACK PANEL - INPUTS/OUTPUTS
FRONT PANEL
1. DC POWER INLET / OUTLET:
The converter suits a DC power plug-
pack input connector. Please ensure the plug-pack used is of an
approved type and of correct current, voltage output, and connector
polarity. DV 12 Volt, power supply 1.25A.
2. POWER LED:
The power switch turns the unit on and off. The
LED will illuminate red to indicate that the switcher is ON and is
receiving power. The Switcher will remember that last state during
a power cycle. When the power is removed and resorted, the last
configuration will be evoked.
3. HDMI INPUT:
Connects a HDMI direct digital video/audio signal link
to the female HDMI connector, which supports HDMI digital video/
audio and DVI digital video sources. If you remove the HDMI screw
posts, you must use the provided HDMI Locking Post replacement
screws to keep the internal HDMI jack secure. Removing the HDMI
screws without installing the HDMI Locking Post replacement
screws will void your warranty.
4. VGA OUTPUT:
Connects a VGA (RGBHV) signal source to the VGA
connector.
5. AUDIO OUTPUT:
Connects the stereo audio output port of your
source audio device to the stereo audio (AR/AL) inputs.
BACK PANEL
POWER JACK:
DC Jack: Inner OD Ø 2.1mm (+)
Power Input: 12VDC, 1.25A
HDMI CONNECTOR:
Note: With proper adapters, the scaler can
be used with DVI digital video signals.
VGA (RGBHV):
Note: With D-SUB-HD15P female socket.
STEREO AUDIO (AR/AL):
phone jack connector.
Note: Female phone jack for each channel.
3
Outside OD Ø 5.5mm (GND)
HDMI female connetor
HD-15P female socket.
Via OD3.5mm ear
Advertisement
