Navigation - ergoline PRESTIGE 1000 INTELLIGENT PERFORMANCE Operating Instructions Manual

Operation
26/74
4.5.2

Navigation

Via the Control Center the most important settings can be made before start-
ing the device. During the tanning session, functions may be activated or
deactivated via the control panel inside the device.
Navigation unit - Control Center
The Control Center enables comfortable access to special functions.
Acknowledge selection.
This button's availability is displayed on the Control Center,
depending on the function that has been selected.
Select device function.
Functions or settings can be activated, deactivated or
changed.
NFC-point
Data exchange via contactless near field communication –
individual settings can be stored on a chip card and called up
again during the next session.
Information about the setting options can be found in the separate user man-
ual 'Control Center' in the folder Technical Documentation.
Navigation unit
The tanning device is operated using the buttons mounted in the operating
handle in the canopy.
Switch tanning on and off, pause.
Confirm function.
This button's availability is displayed on the screen, depend-
ing on the function that has been selected.
Select device function
(go to pictogram).
Select the sub-function (if available).
Alter the setting (for progress bar display),
e.g. regulating the temperature.
Change music title or studio channel (from default mode).
The availability of these buttons is displayed on the screen,
depending on the function that was selected.
All of the pictograms displayed on the screen are illuminated in default mode
after the device starts up.
The relevant pictogram will start to flash after a device function has been
selected. The settings or selection options available for the selected function
will be displayed on the screen, see 'Operating structure' on page 27.
NOTE:
If a button is not pressed within 8 seconds, the settings re-
turn to default mode.