Instructions For Replacing The Lamps; Changing The Chip Card - ergoline PRESTIGE 1000 INTELLIGENT PERFORMANCE Operating Instructions Manual

Cleaning and maintenance
42/74
5.8

Instructions for replacing the lamps

DANGER!
Danger of being burnt by an over-powered lamp!
If the old chip card is left in the device, the new lamp set will
be run at too high power and the user may suffer heavy
burns!
– The enclosed chip card must always be used when
changing the UV low pressure lamps!
The lamp's UV effect and therefore the tanning effect decrease over time. In
electronically controlled low pressure lamps, this loss of effect can be com-
pensated. The chip card is used to control the changing periods. You must
adhere to the replacement intervals specified in the maintenance plan.
UV filters are utilized in order to control the UV radiation, e.g. the filter panels
on the facial tanner. However, the filter effect decreases over the course of
time. Therefore, the intervals specified in the maintenance plan must be ad-
hered to.
5.8.1

Changing the chip card

The chip card belongs to the long UV low pressure lamps fitted in the canopy,
the side panels and the device's base.
The chip cards are located in the 'Part support control'.
– Opening the bed base: see page 41.
– Remove the chip cards belonging to the old lamp set.
– Insert the new chip cards with the arrow pointing downwards. In doing so,
ensure that the chip cards are inserted in the correct sequence.
– Close the bed base. You should hear the bed base click into place.