Omron NX701-17 Series Troubleshooting Manual page 108

3 Error Tables
Event code Event name
54011409 hex That File Name
Already Exists
5401140A hex Write Access
Denied
5401140B hex Too Many Files
Open
5401140C hex Directory Does Not
Exist
5401140D hex File or Directory
Name Is Too Long
5401140E hex SD Memory Card
Access Failed
5401140F hex
Backup Operation
(Ver. 1.08 or
Already in
later)
Progress
54011410 hex
Cannot Execute
(Ver. 1.08 or
Backup
later)
54011411 hex
Unit/Slave Backup
(Ver. 1.08 or
Failed
later)
54011800 hex EtherCAT Commu-
nications Error
54011801 hex EtherCAT Slave
Does Not Respond
54011802 hex EtherCAT Timeout
3-30
Meaning
An instruction could not be • A file already exists
executed because the file
name specified for the
instruction already exists.
An attempt was made to • The file or directory
write to a write-protected
file or directory when an
instruction was executed.
The maximum number of • The maximum number
open files was exceeded
when opening a file for an
instruction.
The directory specified for • The directory specified
an instruction does not
exist.
The file name or directory • The file name or direc-
name that was specified for
an instruction is too long.
SD Memory Card access • The SD Memory Card
failed.
• The SD Memory Card
• Another backup oper-
Another backup operation
is already in progress.
• Execution of the
Execution of a backup
operation was not possible
because execution of
another operation was in
progress.
• Execution of the
• Execution of the
• A Unit/slave backup
A Unit/slave backup
operation failed.
Accessing the EtherCAT • The EtherCAT net-
network failed when an
instruction was executed.
Accessing the target slave • The target slave does
failed when an instruction
was executed.
• The target slave is not
A timeout occurred while • Communications with
trying to access an Ether-
CAT slave when an instruc-
tion was executed.
Assumed cause
Maj Prt
with the same name
as the name specified
for the instruction to
create.
specified for the
instruction to write is
write-protected.
of open files was
exceeded when open-
ing a file for an instruc-
tion.
for an instruction does
not exist.
tory name that was
specified for the
instruction to create is
too long.
is broken.
slot is broken.
ation is already in
progress.
instruction was
attempted during exe-
cution of online edit-
ing.
instruction was
attempted during exe-
cution of a Save Cam
Table instruction.
instruction was
attempted while a
CPU Unit name
change operation was
in progress.
operation failed.
work is not in a usable
status.
not exist.
in an operating condi-
tion.
the target slave timed
out.
NJ/NX-series Troubleshooting Manual (W503)
Level
Refer-
ence
Min Obs Info
S W502
S W502
S W502
S W502
S W502
S W502
S W502
S W502
S W502
S W502
S W502
S W502