WARNING:
To reduce the risk of personal injury, be careful when pressing the server rail-release latches and
sliding the server into the rack. The sliding rails could pinch your fingers.
Remove the server from the rack
To remove the server from a Hewlett Packard Enterprise, Compaq-branded, Telco, or third-party rack,
complete this procedure.
Procedure
1. Power down the server on page 35 .
2. Extend the server from the rack on page 36.
3. Disconnect the cabling and remove the server from the rack. For more information, see the documentation
that ships with the rack mounting option.
4. Place the server on a sturdy, level surface.
Access the product rear panel
Release the cable management arm
Procedure
Release the cable management arm and then swing the arm away from the rack.
Access the Systems Insight Display
The Systems Insight Display is supported only on SFF models. To access the Systems Insight Display, use
the following procedure.
Remove the server from the rack
37