Lan Cable - Furuno DFF-3D Operator's Manual

2.4

LAN Cable

Do as follows to connect the supplied LAN cable (MOD-Z072-050+) or the optional
LAN cable (MOD-Z072-020+, MOD-Z072-100+).
1. Unfasten the sealing nut from the LAN connector then remove the sealing insert
and clamping claw.
2. Detach the sealing insert from the clamping claw as shown below.
Sealing nut
Clamping
claw
Sealing
insert
3. Pass the sealing nut, clamping claw and sealing insert onto the LAN cable in the
order shown in the figure below. Connect the cable to the LAN connector. (Note
the orientation of the sealing insert when passing it onto the cable. Push the cable
into the slit in the sealing insert.)
4. Set the sealing insert and clamping claw into the sealing nut then tighten the nut.
How to detach clamping claw
Super
gland
Sealing nut
Hold the clamping
claw/seal assy. as shown
left, with the teeth of
the clamping claw toward
you.
Push in the sealing insert
with your thumbs.
LAN cable
Sealing insert
(Push cable into slit.)
Clamping claw
2. WIRING
2-9