Furuno DFF-3D Operator's Manual page 33

Motion Sensor menu
Select [Transducer Setup] on the [Multibeam Sonar] menu to show the [Motion Sen-
sor] menu (below the [Transducer Setup] menu).
GC:
If the center of gravity is not known, see the drawing below.
W
H
Note: The location of the center of gravity may be different than as shown in the fig-
ures above, depending on hull shape, engine position and the installation status of
other equipment.
Menu item
[Motion Sensor Select the sensor connected to you NavNet TZtouch2 unit. [SC], [Internal],
Source]
[Motion Sensor Set the distance from the transducer to the motion sensor
Pos. Bow/Stern] in the bow-stern direction. For the stern side, set a positive
value.
Note: This menu appears if the motion sensor source is
selected to [SC].
Port dir.: "+"
TD GC
Stern dir.: "+"
Up dir.: "+"
GC
TD
Center, TD: Transducer, SC: Satellite Compass
Gravity
GC: Gravity Center, TD: Transducer
W/2
Engine
GC
L/3
L
Engine
GC
H/2
GC: Gravity Center
Description
SC Top view
SC
Starboard view
Top view
Starboard view
3. INITIAL SETTINGS
Options
(setting range)
[OFF]
-100 to 100.0 (m)
3-7