Furuno DFF-3D Operator's Manual page 32

3. INITIAL SETTINGS
Transducer Setup menu
For the oscillation center see "Motion Sensor menu" on the next page.
If the center of gravity is not known, see the drawing below.
W
H
Note: The location of the center of gravity may be different than as shown in the fig-
ures above, depending on hull shape, engine position and the installation status of
other equipment.
Menu item
[Transducer Mis-
mount Correction]
[Transducer Position
Bow/Stern]
[Transducer Position
Up/Down]
[Transducer Position
Port/Starboard]
3-6
Port dir.: "+"
TD GC
Stern dir.: "+"
Up dir.: "+"
GC
TD
GC: Gravity Center, TD: Transducer
W/2
Engine
GC
L/3
L
Engine
GC
H/2
GC: Gravity Center
Description
Set to [ON] if the transducer is installed facing the stern.
Set the distance from the transducer to the ship's center
of gravity in the bow/stern direction. For stern location,
set a positive value.
Set the distance from the transducer to the ship's center
of gravity in the up/down (vertical) direction. For upward
location, set a positive value.
Set the distance from the transducer to the ship's center
of gravity in the port/starboard direction. For port location,
set a positive value.
Top view
Starboard view
Top view
Starboard view
Options
(setting range)
[ON], [OFF]
-100.0 to 100.0
(m)
-100.0 to 100.0
(m)
-100.0 to 100.0
(m)