Furuno DFF-3D Operator's Manual page 34

3. INITIAL SETTINGS
Menu item
[Motion Sensor Set the distance from the transducer to the motion sensor
Pos. Up/Down] in the up/down (vertical) direction. Use a "+" value for up-
ward direction.
Note: This menu appears if the motion sensor source is
selected to [SC].
[Motion Sensor Set the distance from the transducer to the motion sensor
Pos. Port/Star- in the port-starboard direction. For port location, set a pos-
board] itive value.
Note: This menu appears if the motion sensor source is
selected to [SC].
[GPS Sensor Set the distance from the transducer to the GPS sensor in
Pos. Bow/Stern] the bow-stern direction. For stern location, set a positive
value.
[GPS Sensor Set the distance from the transducer to the GPS sensor in
Pos. Up/Down] the up/down (vertical) direction. Use a "+" value for upward
direction.
[GPS Sensor Set the distance from the transducer to the GPS sensor in
Pos. Port/Star- the port-starboard direction. For port location, set a posi-
board] tive value.
[Roll Sensor Off- Set the roll offset to use with the internal motion sensor.
set] Note: This menu appears if the motion sensor source is
selected to [Internal].
[Pitch Sensor Set the pitch offset to use with the internal motion sensor.
Offset] Note: This menu appears if the motion sensor source is
selected to [Internal].
[Motion Sensor Set the time lag to use with the external motion sensor.
Time Lag (in ms)] Note: This menu appears if the motion sensor source is
selected to [SC].
[Heading Sensor Set the time lag for the data received from the position sen-
Time Lag (in ms)] sor.
[Position Sensor Set the time lag for the data received from the position sen-
Time Lag (in ms)] sor.
Sync (time lag) setting
• If the equipment is connected as shown below, no adjustment to the time lag set-
tings is necessary.
3-8
Description
Multi Function
DFF-3D ------------------
Display
Ethernet
Motion sensor time lag: 20 msec
Heading sensor time lag: 20 msec
Position sensor time lag: 20 msec
(setting range)
-100 to 100.0 (m)
-100 to 100.0 (m)
-100 to 100.0 (m)
-100 to 100.0 (m)
-100 to 100.0 (m)
-45.0 to 45.0
-45.0 to 45.0
0 to 400
0 to 3500
0 to 3500
------------ SC-30
CAN bus
Options