Furuno DFF-3D Operator's Manual page 22

2. WIRING
e) Remove 5 mm of the vinyl sheath from the cores then connect a crimp-on lug
to each core as shown below.
f) Attach supplied crimp-on lug (FV1.25-4(LF) RED)) to the shield.
g) Referring to the illustration below, wrap the armor with vinyl tape at the loca-
tions shown. Pass the cable through its cable gland. Fix the cable with the ca-
ble clamp and sealing nut.
Armor
Wrap with
vinyl tape.
2. Remove the outer cover.
3. Loosen four screws to remove the inner chassis cover.
4. Detach the protective sheet from the location for the external KP cable.
2-6
Vinyl sheath
This part is fixed with
the sealing nut.
Protective sheet
Approx. 5 mm
Lay this part in
Crimp-on lug
the cable clamp.
FV1.25-4(LF) RED
Wrap with
NCW-1.25
vinyl tape.