Installing The Bs-Sh-Vl Chassis And Modules - Alvarion BreezeACCESS VL 5.4 System Manual

Breezeaccess vl series
Table of Contents

Advertisement

Installation
♦ RADIO: A 10/100BaseT Ethernet connector for connecting the
BS-AU-VL to an AU-RE outdoor unit.
The recessed RESET switch on the front panel is for resetting the outdoor
unit.
Installing the BS-SH-VL Chassis and
Modules
This section describes how to install the the power supply and Access Unit
network interface modules in the Base Station chassis.
To install the BS-SH Chassis and Modules:
1.
Install the BS-SH-VL chassis in a 19 inch cabinet. To prevent over-
heating, leave a fee space of at least 1U between the upper/lower
covers of the BS-SH-VL chassis and other units in the cabinet.
or
Place the BS-SH-VL chassis on an appropriate shelf or table. When
mounting the BS-SH-VL on a shelf or table, attach the rubber legs
supplied with the unit.
2.
Connect one end of a grounding cable to the ground terminal located
on the back panel of the BS-SH-VL chassis and firmly tighten the
ground screw.
3.
Connect the opposite end of the ground cable to a ground connection
or to the cabinet, if applicable.
4.
Carefully insert the BS-PS-VL power supply and the BS-AU-VL
modules into the relevant slots and push firmly until they are securely
locked. Before insertion, verify that the switches of all BS-PS-VL
modules are in the OFF position. Refer to BS-SH Slot Assignments on
page 3-12 for a description of the slot assignments.
5.
Close the captive screws attached to each module.
6.
Place blank covers over all of the unused slots.
7.
Connect the indoor-to outdoor cable(s) to the RADIO connector(s) of
the AU-NI-BS module(s).
8.
If a BS-PS-DC-VL power supply is used, connect the DC power cord to
the –48 VDC In jack of the BS-PS-DC-VL power supply. If a redundant
power supply module is installed, connect a DC power cord also to the
second DC power module. Connect the power cord(s) to the -48VDC
power source, as follows.
Connect the black wire to the -48VDC contact of the power
a.
source.
Connect the red wire to the + (Return) contact.
b.
3-15

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Su-a-24-vlSu-ra-vlSu-ni-vlSu-a-54-vl

Table of Contents