Alvarion BreezeACCESS VL 5.4 System Manual page 121

Software Version Loading Using TFTP
Firmware upgrades to the unit's FLASH memory can be performed by a
simple loading procedure using a TFTP application. Before performing an
upgrade procedure, be sure you have the correct files and most recent
instructions.
Upgrade packages can be obtained from the Technical Support section of
Alvarion's web site, www.alvarion.com.
NOTE:
Shutting down power to the unit before completion of the loading procedure may cause the
unit to be inoperable.
To load software versions:
1.
Verify that IP connectivity to the required unit is established.
2.
Ensure that the IP address of the PC from which the upgrade is to be
performed belongs to the same subnet as the unit to be upgraded,
unless the unit is behind a router. If the unit is behind a router, verify
that the unit is configured with the correct Default Gateway
Address.
3.
To view the current IP parameters of the unit, use the Monitor
program by connecting the PC to the unit either directly or via Telnet.
To access the IP parameters via the Monitor program:
From the Main Menu select 1 – Info Screens.
a.
From the Info Screen menu select 2 – Show Basic
b.
Configuration. The current basic configuration is displayed,
including the run-time values for the IP Address, Subnet Mask and
Default Gateway Address parameters.
4.
To modify any of the IP parameters:
From the Main Menu, select 3 – Basic Configuration.
a.
To configure the IP address, select: 1 – IP Address.
b.
To configure the subnet mask, select 2 – Subnet Mask.
c.
Appendix A
Software Version
Loading Using
A-1
TFTP