Alvarion BreezeACCESS VL 5.4 System Manual page 118

5-58
Service Parameters (SU Only)
The Service Parameters menu enables defining user filtering parameters.
The Service Parameters menu is only available to Subscriber Units and
includes the following parameters:
User Filtering Parameters
The User Filtering Parameters submenu enables defining the IP addresses
of user devices authorized to access the wireless media for security and/or
control purposes. In addition, it can be used to enable the transmission
and reception of specific protocol frames. These filtering options do not
affect management frames sent to or generated by the unit.
The User Filtering Parameters menu provides the following options:
User Filtering Option
The User Filtering Option disables or enables the User Filtering feature.
The following options are available:
♦ Disable, which means no filtering.
♦ IP only, which means only IP Protocol packets pass.
♦ User Defined Addresses Only, which means only IP frames from/to IP
addresses included in the User Filter Addresses list pass.
♦ PPPoE Protocol Only, which means only PPPoE messages pass
(Ethernet type 0x8863 and 0x8864).
The default selection is Disable.
Set User Filter Address
The Set User Filter Address option enables entering up to 8 IP addresses
from/to which IP frames are to pass if the User Defined Addresses Only
option is selected in the User Filtering Option parameter.
The default for all addresses is 0.0.0.0.
Set User Filter Mask
The Set User Filtering Mask option enables entering subnet masks for each
of the User Filter IP Address entries.
The default for all subnet masks is 255.255.255.255.
BreezeACCESS VL System Manual