Replacing Fuses - Nakanishi E3000 Operation Manual

⑳ Warning LED (WARNING)
The operating and working conditions of the system are constantly monitored and the Warning LED
(WARNING) flashes when a hazardous condition has been detected. When a hazardous condition is
detected the Warning LED (WARNING) ashes and the Digital Speed Indicator ⑪ alternates between the
Warning Code and the actual or preset speed, depending on whether or not the motor / spindle is rotating or
not.
Rotating LED (RUN)
When the motor is rotating this LED will illuminate.

10 . REPLACING FUSES

WARNING
・ Before removing the fuse holder and fuses, be sure that the Main Power Switch ⑨ is turned OFF
and the Power Cord has been removed from the CONTROLLER.
・ Verify type and use only following the properly rated and type of fuse.
Speci ed fuses ： T1.6AL (250V)
* Failure to use the proper type and rated fuse will result in re, injury, electric shock and / or
product damage.
(1) Push on the clips on the right and left of the fuse holder and
remove the fuse holder block.
(2) Remove the bad fuse or fuses and replace with the proper
type and rating of fuse by the input voltage being used.
(3) Replace the fuse holder containing the fuses into the Main
Power Inlet with Power Supply Fuses ⑩ and make sure it
snaps in place.
Cap
Fig. 14
61