Cautions For Handling And Operation - Nakanishi E3000 Operation Manual

B. OTHER WARNING INSTRUCTIONS
1 . For your own safety read instruction manual before operating this tool.
2 . Replace cracked collet or collet nut immediately.
3 . Do not over tighten the collet nut.
4 . Use only NAKANISHI manufactured collets and arbors for grinding and sawing applications.
5 .
REMOVE ADJUSTING KEYS AND WRENCHES. Always check to see that keys and adjusting wrenches are
removed from tool before turning the units Main Power Switch on.
6 . KEEP WORK AREA CLEAN. Cluttered areas and benches invite accidents.
7 .
DO NOT USE IN DANGEROUS ENVIRONMENTS. Don't use power tools in damp or wet locations, or expose
them to rain.
8 .
Keep work area well lighted.
9 .
There is a risk of injury due to accidental starting. Do not use in an area where children may be present.
10 . DO NOT FORCE THE TOOL. Never use a tool for an application it was not designed for.
11 . USE THE CORRECT TOOL. Do not force tools or attachments to do a job for which it was not designed.
12 . WEAR PROPER APPAREL. Do not wear loose clothing, gloves, neck ties, rings, bracelets, or other
jewelry that might get caught in moving parts. Nonslip footwear is recommended. Wear protective hair
covering to contain long hair.
13 . ALWAYS USE SAFETY GLASSES. Everyday eyeglasses only have impact resistant lenses, they are
NOT safety glasses. Also use face or dust mask if cutting operation is dusty.
14 .
SECURE YOUR WORK. Use clamps or a vise to hold work securely at all times.
15 .
MAINTAIN TOOLS WITH CARE. Keep tools sharp and clean for best performance and to reduce the risk of
injury. Follow instructions for changing accessories.
16 .
DISCONNECT TOOLS before servicing or when changing accessories, such as blades, cutters etc.
17 .
REDUCE THE RISK OR UNINTENTIONAL STARTING. Make sure Main Power Switch is in OFF position
before plugging in.
18 .
NEVER LEAVE TOOLS RUNNING UNATTENDED. TURN POWER OFF. Don't leave the tool until it comes to
a complete stop.
19 .
For recommended operating speeds for various applications, please follow recommendations of the cutting tool
manufacturer.

1 . CAUTIONS FOR HANDLING AND OPERATION

■ Read these warnings and cautions carefully and only use in the manner intended.
■ These warnings and cautions are intended to avoid potential hazards that could result in personal injury or
damage to the device. These are instructions are classi ed as follows in accordance with the seriousness
of the risk.
Class
DANGER Existence of a hazard that.
A hazard that could result in bodily injury or damage to the device if the
WARNING
safety instructions are not properly followed.
A hazard that could result in light or moderate bodily injury or damage to
CAUTION
the device if the safety instructions are not followed.
DANGER
Do not rotate the machining center's main spindle with the
HES installed.
Rotating the machining center's main spindle with the HES
installed can cause the motor cord to become tangled and pull
the CONTROLLER off its mounting.
Degree of Risk
49