Nakanishi E3000 Operation Manual page 38

Ultra-precision, high-speed spindle system
Hide thumbs Also See for E3000:
Table of Contents

Advertisement

Table. 9
Types
Code
Setting of Error Output Mode
Setting AUTO Mode for Motor
Speed Control
Setting Fixed Motor Speed
Setting Maximum Motor Speed
Selection of External Speed
Control Mode
Selection of External Motor Start
Signal Control Mode
Selection of Air Input Monitoring
Override
Selection of Motor Speed Control
Voltage / DC+ 10 V Signal Method
Selection of Emergency Stop
Function
Error History
Con rmation of Parameter
Setting
Contents
Changes the Error Output Signal, when an error occurs
from normally open to normally closed.
When the control is in AUTO mode, the speed
control is adjustable from the Control Panel ② of the
CONTROLLER or the SELECTOR, set the parameter
to on to adjust the speed in AUTO Mode.
When Fixed Motor Speed is desired, set the parameter
to
and set the desired locked in speed. (When
CONTROLLER and SELECTOR are connected, 4
motors are set to the same motor rotation speed.)
When Maximum Motor Speed is desired, set the
parameter to
and set the maximum speed. (When
CONTROLLER and SELECTOR are connected, 4
motors are set to the same maximum motor rotation
speed.)
The following Rotation Speed options can be selected
when control mode is AUTO.
: Analog Signal  
: Speed Point Signal
When control mode is in AUTO, please set the
parameter to
and set the desired rotating
direction of the motor. Activate Pin 2 to set a reverse
direction along with the start command.
If want to start the motor without supplying cooling
air, please set the parameter to
parameter, motor speed will be limited to 30 , 000 min
(rpm).)
When using the Motor Speed Control Voltage Signal
- 1
and using a 80 , 000 min
Mode, please set the parameter to
When using the Emergency Stop Selection Mode,
please set the parameter to
Error code history of the last 5 error events can be
con rmed. (No parameter setting is necessary.)
Contents of the parameters that are set can be
confirmed. (
-
necessary.)
: Pulse Signal  
. (When set this
(rpm) motor, in AUTO Control
.
.
.) No parameter setting is
Default
- 1
83

Advertisement

Table of Contents
loading

Table of Contents