Disposal Of The Controller - Nakanishi E3000 Operation Manual

Trouble
Tool slippage.
High run-out.

21 . DISPOSAL OF THE CONTROLLER

When disposal of a CONTROLLER is necessary, follow the instructions from your local government agency for
proper disposal of industrial components.
Cause
Collet or collet nut are not correctly
installed.
The collet and the collet nut are worn.
The cutting tool is bent.
Collet nut is not correctly installed.
The collet and the collet nut are worn.
Inside of the spindle is worn.
Contaminants inside the collet and the
collet nut or the spindle.
The spindle ball bearings have been
damaged.
Inspection / Corrective Active
Check and clean the collet and collet nut.
Reinstall the collet and collet nut.
Replace the collet and collet nut.
Change the cutting tool.
Secure the collet and the collet nut
correctly.
Replace the collet and the collet nut.
Replace the spindle shaft.
(Return to NAKANISHI dealer service.)
Clean the collet, collet nut and the inside
of the taper and spindle.
Replace the ball bearings.
(Return to NAKANISHI dealer service.)
95