Configuring A Static Ipv6Sg Binding - HPE FlexNetwork 5510 HI Series Security Configuration Manual

Step
3. Enable the IPv6SG feature.

Configuring a static IPv6SG binding

You can configure global static and interface-specific static IPv6SG bindings.
Global static bindings take effect on all interfaces.
Interface-specific static bindings take priority over global static bindings. An interface first uses the
static bindings on the interface to match packets. If no match is found, the interface uses the global
bindings.
Configuring a global static IPv6SG binding
Step
1. Enter system view.
2. Configure a global
static
binding.
Configuring a static IPv6SG binding on an interface
Step
1. Enter system view.
2. Enter interface view.
3. Configure
IPv6SG binding.
Command
ipv6 verify source { ip-address |
ip-address
mac-address }
Command
system-view
ipv6 source binding ip-address ipv6-address
IPv6SG
mac-address mac-address
Command
system-view
interface
interface-number
ipv6 source
{ ip-address ipv6-address |
a static
ip-address
mac-address mac-address |
mac-address mac-address }
[ vlan vlan-id ]
mac-address |
Remarks
N/A
The
supported:
interface-type
•
Layer 2 Ethernet interface.
•
Layer 3 Ethernet interface.
•
VLAN interface.
By default, no static IPv6SG binding is
configured on an interface.
Support for the mac-address and vlan
keywords depends on the device model.
binding
The vlan vlan-id option is supported only in
ipv6-address Layer 2 Ethernet interface view.
To configure a static IPv6SG binding for
the ND detection function, the vlan vlan-id
option must be specified, and ND detection
must be enabled for the specified VLAN.
You can configure the same static IPv6SG
binding on different interfaces.
404
Remarks
•
Layer 3 aggregate interface.
By default, the IPv6SG feature is
disabled on an interface.
If you configure this command on
an interface multiple times, the
most recent configuration takes
effect.
Remarks
N/A
No global static IPv6SG
binding exists.
following interface types are