Configuring Extended Re-Dhcp Portal Authentication - HPE FlexNetwork 5510 HI Series Security Configuration Manual

Hide thumbs Also See for FlexNetwork 5510 HI Series:
Table of Contents

Advertisement

Layer3 source network:
IP address
Destination authenticate subnet:
IP address
IPv6:
Portal status: Disabled
Authentication type: Disabled
Portal Web server: Not configured
Authentication domain: Not configured
Bas-ipv6: Not configured
User detection: Not configured
Action for server detection:
Server type
--
Layer3 source network:
IP address
Destination authenticate subnet:
IP address
Before a user performs portal authentication by using the HPE iNode client, the user can access only
the authentication page http://192.168.0.111:8080/portal. All Web requests the user initiates will be
redirected to the authentication page.
If the user passes the authentication but fails the security check, the user can access only the
resources that match ACL 3000.
After passing both the authentication and the security check, the user can access Internet
resources that match ACL 3001.
# After the user passes authentication, use the following command to display information about the
portal user.
[Switch] display portal user interface vlan-interface 100
Total portal users: 1
Username: abc
Portal server: newpt
State: Online
Authorization ACL: 3001
VPN instance: --
MAC
0015-e9a6-7cfe

Configuring extended re-DHCP portal authentication

Network requirements
As shown in
obtains an IP address through the DHCP server. A portal server acts as both a portal authentication
server and a portal Web server. A RADIUS server acts as the authentication/accounting server.
Configure extended re-DHCP portal authentication. Before passing portal authentication, the host is
assigned a private IP address. After passing portal identity authentication, the host obtains a public
IP address and accepts security check. If the host fails the security check, it can access only subnet
192.168.0.0/24. After passing the security check, the host can access Internet resources.
Server name
--
IP
2.2.2.2
Figure
56, the host is directly connected to the switch (the access device). The host
Mask
Mask
VLAN
Interface
100
Vlan-interface100
162
Action
--
Prefix length
Prefix length

Hide quick links:

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the FlexNetwork 5510 HI Series and is the answer not in the manual?

Table of Contents

Save PDF