HPE FlexNetwork 5510 HI Series Security Configuration Manual page 159

Figure 42 Network diagram
Host
2.2.2.2/24
Gateway: 2.2.2.1/24
Configuration prerequisites
•
Configure IP addresses for the host, switch, and servers as shown in
they can reach each other.
•
Configure the RADIUS server properly to provide authentication and accounting functions.
Configuring the portal authentication server on IMC PLAT 3.20
This example assumes that the portal server runs on IMC PLAT 3.20-R2602P13 and IMC UAM
3.60-E6301.
1. Configure the portal authentication server:
a. Log in to IMC and click the Service tab.
b. Select Access Service > Portal Service Management > Server from the navigation tree
to enter the portal server configuration page, as shown in
c. Configure the portal server parameters as needed.
This example uses the default values.
d. Click OK.
Figure 43 Portal authentication server configuration
2. Configure the IP address group:
a. Select Access Service > Portal Service Management > IP Group from the navigation
tree to enter the portal IP address group configuration page.
b. Click Add to enter the page shown in
c. Enter the IP group name.
d. Enter the start IP address and end IP address of the IP group.
Make sure the host IP address (2.2.2.2) is in the IP group.
Vlan-int100
Vlan-int2
2.2.2.1/24
192.168.0.100/24
Switch
Portal server
192.168.0.111/24
RADIUS server
192.168.0.112/24
Figure 44.
146
Figure 42 and make sure
Figure 43.