Enabling Snmp Notifications For Port Security; Displaying And Maintaining Port Security - HPE FlexNetwork 5510 HI Series Security Configuration Manual

This feature does not apply to VLAN authorization failure. The device logs off these users directly.
To enable the authorization-fail-offline feature:
Step
1. Enter system view.
2. Enable
authorization-fail-offline
feature.

Enabling SNMP notifications for port security

IMPORTANT:
This feature is available in Release 1121 and later.
Use this feature to report critical port security events to an NMS. For port security event notifications
to be sent correctly, you must also configure SNMP on the device. For more information about SNMP
configuration, see the network management and monitoring configuration guide for the device.
For this feature to take effect, make sure the intrusion protection feature is configured.
To enable SNMP notifications for port security:
Step
1. Enter
view.
2. Enable
notifications
port security.

Displaying and maintaining port security

Execute display commands in any view:
Task
Display the port security configuration,
operation information, and statistics.
Display information about secure MAC
addresses.
Display information about blocked MAC
addresses.
Command
system-view
the
port-security authorization-fail
offline
Command
system
system-view
snmp-agent
SNMP
[ address-learned | dot1x-failure | dot1x-logoff |
for
dot1x-logon | intrusion | mac-auth-failure |
mac-auth-logoff | mac-auth-logon ] *
trap enable port-security
Command
display port-security
interface-number ]
display port-security mac-address security [ interface
interface-type interface-number ] [ vlan vlan-id ] [ count ]
display port-security
interface-type interface-number ] [ vlan vlan-id ] [ count ]
195
Remarks
N/A
By default, this feature is disabled,
and the device does not log off
users who fail ACL or user profile
authorization.
Remarks
N/A
By default,
notifications are disabled
for port security.
[ interface interface-type
mac-address block
SNMP
[ interface