ICP DAS USA tDS-722 User Manual page 45

Tiny Serial-to-Ethernet Device Server
The following is an overview of the parameters contained in the Port1 Settings section:
Item
Port Settings
Baud Rate (bps)
Data Size (bits)
Parity
Stop Bits (bits)
Flow Control
Allow Driver Control
Operation Mode
Local TCP Port
Connection Idle (seconds)
Prefix String
Serial Data Packing
Slave Timeout (ms)
Copyright © 2016 ICP DAS CO., Ltd. All Rights Reserved.
Description
This parameter is used to set the Baud Rate for the
COM ports.
This parameter is used to set the Data Size for the
COM ports.
This parameter is used to set the Parity for the COM
ports.
This parameter is used to set the Stop Bits for the
COM ports.
This parameter is used to set the Flow Control for the
COM ports.
Enable client (VxComm Driver) to dynamically change
the data format and baud rate settings.
M0/Multi-echo: Share received serial data between
clients.
M1/Single-echo: Send received serial data to the
requested client only.
0 = Data-sharing; 1 = Non-sharing
TCP Command Port +1
Note:
COM1/COM2/COM3 = TCP port 10001/10002/10003
If the Local TCP port does not receive any data via the
TCP/IP for a certain period, the tDS-700 will
disconnect the socket based on the TCP timeout
value.
Settings range: 1 ~ 65535 (seconds); Disabled: 0;
This parameter is used to set the first character in a
line of data.
Settings range: Max. 8 chars.
Set the waiting time after last Tx of the request sent
to the device. If the device does not respond within
the timeout value, the tDS-700 will return existing
data via TCP package and process next request.
Default
115200
8
None
1
None
Enable
0
10001
180
1000
- 45 -