ICP DAS USA tDS-722 User Manual page 55

Tiny Serial-to-Ethernet Device Server
1. Confirm that the tDS-700 modules are functioning correctly. Refer to
tDS-700 module for more details.
2. Wire the slave device (Ex: M-7015, optional) with your tDS-700. For detailed RS-422/485 wiring
information, refer to
3. Supply power to the slave device (Ex, M-7015, Device ID: 2, +10~+30 VDC power used.)
4. Install VxComm utility, and then configuration Ethernet setting (such as IP/Mask/Gateway
details) for tDS-700 series module; refer to
5. Confirm the serial port settings (baud Rate and data format) must be the same between the
tDS-700 and slave device (M-7015).
For example:
Model
tDS-700
Slave Device (M-7015)
6. Right click in the "Configure Port" area and then choose the "Open TCP Port" item under the
VxComm utility.
Copyright © 2016 ICP DAS CO., Ltd. All Rights Reserved.
section 2.7 "Wiring Notes for RS-232/485/422
Chapter 3 Setting up the tDS-700 module.
Baud Rate
Interfaces".
Port Settings
Data Format
9600 8,N,1
9600 8,N,1
Chapter 3 Setting up the
TCP Port
10001
-
- 55 -