Setting Up The Tds-700 Module - ICP DAS USA tDS-722 User Manual

Tiny Serial-to-Ethernet Device Server

3. Setting up the tDS-700 Module

This chapter provides detailed information about the "Self-Test" process, which is used to confirm
that the tDS-700 series module is operating correctly. Before beginning the "Self-Test" process, the
wiring test, Ethernet configuration and VxComm utility driver installation procedures must first be
fully completed. Follow the procedure described below:
Step 1: Connect the Power Supply and the Host PC
1. Ensure that the network settings on your PC are configured correctly.
2. Ensure that the Windows firewall or any Anti-Virus firewall software is correctly
configured or temporarily disable these functions; otherwise the
function in the eSearch Utility may not work as required. You may need to contact your
System Administrator for more details of how to do this.
3. Check that the Init/Run switch is in
the "Run" position.
4. Connect both the tDS-700 and the Host computer to the same sub-network or the same
Ethernet Switch, and then power on the tDS-700. Refer to
illustrations of how to do this.
Copyright © 2016 ICP DAS CO., Ltd. All Rights Reserved.
"Search Servers"
Figure 3-1
Figures 3-2 and 3-3 for
- 25 -