6 Board Test System
PMA Setting
Allows you to make changes to the PMA parameters that affect the active transceiver
interface. The following settings are available for analysis:
•
Serial Loopback: Routes signals between the transmitter and the receiver.
•
VOD: Specifies the voltage output differential of the transmitter buffer.
•
Pre-emphasis tap:
— 1st pre: Specifies the amount of pre-emphasis on the pre-tap of the
transmitter buffer.
— 2nd pre (L-Tile): Specifies the amount of pre-emphasis on the second pre-tap
of the transmitter buffer.
— 1st post: Specifies the amount of pre-emphasis on the first post tap of the
transmitter buffer.
— 2nd post (L-Tile): Specifies the amount of pre-emphasis on the second post-
tap of the transmitter buffer.
•
Equalizer: Specifies the AC gain setting for the receiver equalizer in four stage
mode.
•
DC gain: Specifies the DC gain setting for the receiver equalizer in four stage
mode.
•
VGA: Specifies the VGA gain value.
®
®
Intel
Stratix
10 GX Transceiver Signal Integrity Development Kit User Guide
57