Setting Agent, Vaporizer, and Oxygen Controls
1. Touch the Agent Type box (see Figure 4-6). The border of the box flashes red when active.
2. Select the agent type (ISO, SEVO, or NONE) using the
3. Touch the Agent Concentration Percent box. The border of the box flashes red when active.
4. Use the
buttons to set the desired percentage.
5. Repeat Steps 1-4 for the other anesthetic agent.
6. Touch the green button ( ) at the bottom of the Oxygen Flow Indicator. The border of the
indicator flashes red when active.
7. Select the desired O
Note: The case clock begins as soon as O
Agent
Concentration %
Case Clock
Oxygen Flow l/min.
System Setup
flow rate using the
2
10:47
Sat Jun 26
2.5
Figure 4-6 Agent, Vaporizer, and Oxygen Controls
buttons.
buttons.
flow begins.
2
Agent Type (Active)
Increase (Up)
Decrease (Down)
4-7