Kyocera ECOSYS M4125idn Operation Manual page 488

Appendix > Paper
Curl
Most paper naturally tends to curl after the package is opened. When paper passes through the fixing unit, it curls
upward slightly. To deliver flat printouts, load the paper so that the curl faces towards the bottom of the paper tray.
Static electricity
During printing, paper is electrostatically charged so that the toner adheres. Choose paper that can be discharged
quickly so that copies do not cling together.
Whiteness
Paper whiteness affects print contrast. Use whiter paper for sharper, brighter copies.
Quality
Machine problems may occur if sheet sizes are not uniform or if corners are not square, edges are rough, sheets are
uncut, or edges or corners are crushed. In order to prevent these problems, be especially careful when you cut the
paper yourself.
Packaging
Choose paper that is properly packaged and stacked in boxes. Ideally, the packaging itself should have been treated
with a coating to inhibit moisture.
Specially treated paper
We do not recommend printing onto the following types of paper, even if it conforms to the basic specifications. When
you use these kinds of paper, purchase a small amount first as a sample to test.
• Glossy paper
• Watermarked paper
• Paper with an uneven surface
• Perforated paper
Paper Sizes that can be Used with This Machine
Paper of the following sizes is supported by the machine.
Measurements in the table take into account a ±0.7 mm dimensional accuracy for length and width. Corner angles must
be 90° ± 0.2°.
• A3 (297 × 420 mm)
• A4 (297 × 210 mm)
• A5 (210 × 148 mm)
*1
• A6 (148 × 105 mm)
• B4 (257 × 364 mm)
• B5 (257 × 182 mm)
*1
• B6 (182 × 128 mm)
• 216 × 340 mm
• Ledger
• Letter
• Legal
• Statement
• Executive (7-1/4 × 10-1/2")
• Oficio II
• Folio (210 × 330 mm)
*1
12-16