Caller Id - UTStarcom UTS708SY Instruction Manual

*SM-801 PHS/sec2(GB) 00.3.9 4:31 PM
2. Before using your phone

CALLER ID

Your number is very important. Be sure to register it correctly.
Caller ID lets the party you call know who's calling.
This function is turned on by default.
Press es8s1
1
or esus[
• The current setting flashes.
Press o (On)
2
Press u (Off)
NOTES
• If the party you are calling does not have a phone with Caller ID, they will not
know who is calling even if this function is on.
Page 34
34
DISPLAYING TIME AND DATE
Once the date and time have been set, they can be displayed when in the standby
mode. The default date and time are January 1, 2000, 00:00.
• The date and time recorded in the redial log and incoming call log will be dis-
played once the date and time are set.
• The time and date must be set for the scheduler (p. 68), anniversary (p. 72),
and alarm (p. 74) functions.
Press es4s0
1
or esus[
• If already set, the stored date and time will be displayed.
Press esEnter date and timese ex.: July 1, 2000, 12:30
2
1. Enter the last two degits of the year, month, day.
0 s 0s0s7s0s1
2. Enter the hour and minute.
1s2s3s0
• To edit
Use p or -= to move the cursor, and enter the date or time.
• If an invalid date or time is entered
An alarm will beep. Enter it again.
Date and time display
• Date and time are set.
NOTES
• The date and time will be reset to the default values if the battery is removed
or completely discharged. Simply reset the date and time.
• The clock is accurate to within approximately 60 seconds a month at 25˚C.
35
2. Before using your phone
• Date and time are not set.