Using This Manual - UTStarcom UTS708SY Instruction Manual

1. Introduction
CAUTIONS ON USE
• Do not scrape the phone against hard surfaces.
The finish could be damaged.
• Batteries are consumables.
Batteries wear out in time. The battery should be replaced when it can only be
used for about half as long as a new battery. See page 2-4.
• Electronic eavesdropping
This product digitally processes your voice before transmission. This increases
security and makes it more difficult for someone to electronically eavesdrop on
your conversation. Electronic eavesdropping cannot, however, be entirely pre-
vented if someone has the certain equipment. Remember this before talking
about sensitive matters over your PHS phone.
• Standby time
Standby time in the public mode within your service area is approximately 700
hours at 25°C with good, stable signal quality. Standby time will decrease
depending on current conditions, particularly outside your service area and in
areas where reception is not possible. Using the phone book, programming
entries, and using the game feature will also shorten the standby time.
UTSTARCOM EXPRESSLY TAKES NO RESPONSIBILITY FOR ANY
•
ECONOMIC LOSSES OR DAMAGES THAT MIGHT OCCUR AS A RESULT
OF PRODUCT FAILURE, IMPROPER OPERATION, DEFECTS, POWER
FAILURES, OR OTHER FACTORS THAT MIGHT PREVENT THE USER
FROM PLACING OR RECIEVING A CALL.
NOTICE
This product is for use in THAILAND only. Use outside THAILAND is
prohibited.
16

USING THIS MANUAL

Reading the display
The flashing on the display is shown as
Using the cursor
Search, selection, adjustment, and setting operations can be per-
formed by pressing and pressing the cursor up, down, left, or
right. The direction of the cursor pressed is shown throughout this
manual using the illustrations below.
Cursor operation is described more fully in the specific functions.
Up Down Up or down
REMEMBER: Press the cursor lightly.
Key operating sequence
A number of keys must usually be pressed for specific operations. The sequence in
which the keys are pressed is shown throughout this manual as follows.
ex.:
.> >
In this case, first press , then
Note: If no key is pressed for a specific time while using a selected function, the
phone will automatically return to the standby mode or in-use display. The
system is called "time out" when this happens.
The time out delay: approximately 60 seconds.
Some operations do not, however, return to the standby mode automatically.
To return to the standby mode in these cases, press
ation. Continuing to display the control screen will reduce the battery power faster.
To return to the previous screen
Press .
To interrupt a function and return to the standby mode
Press and hold .
1 .Introduction
. ex.:
Right Left Riht or left
, then .
after completing the oper-
17