Reading The Display - UTStarcom UTS708SY Instruction Manual

Table of Contents

Advertisement

*SM-801 PHS/sec1(GB)
00.3.9 4:16 PM
1. Introduction

READING THE DISPLAY

q Either dialing or a call is connected. If not visi-
ble, calls cannot be made (e.g., you are out
of range).
w Indicates signal quality. The more bars there
are displayed, the better the signal quality is.
e Digital cordless extension phone
r Transceiver mode
t Battery level indicator. Indicates remaining
battery capacity in the standby mode. (p. 20, 24)
y Dial lock or key lock function has been set.
u Indicates the alarm clock has been turned on. Flashes when the set time is
reached.
i Indicates the secret phone book feature has been turned on.
o Indicates a message has been recorded. The number of messages is shown on
the right.
!0 Lights when a call was received but not answered.
!1 Display
Displays entered phone numbers and text.
NOTES
• Pressing any key causes the key and the display backlight to turn on for
approximately 10 seconds. The display backlight is always on when the game
mode is selected. (p. 77)
Page 20
BATTERY INDICATOR
DURING STANDBY MODE
NOTES
•The battery level indicator
is only a guide.
The level indicator will vary
depending on operating
conditions.
•If CHARGE BATTERY is
displayed
Only the w can be used.
20
YOU CAN'T USE THE PHONE WHILE;
DISPLAY
CAUSE
Public mode
Outside the service area (or
signal reception is too poor).
Home mode
Signals not received from the
base station.
Home/public mode
Outside the service area (or
signal reception is too poor), or
signals not received from the
base station.
WARNING will flash when in
the public mode and you
approach an area where
dropped calls are likely, and an
alarm will sound.
Lock phone is on to prevent key
operations.
Key guard is on to prevent dial-
ing.
Charge will flash when battery
capacity is low. If the phone is
in use, an alarm will sound and
about 1 minute later, the call
will be cut off. If in the standby
mode, a beep will sound for
about 15 seconds, and the
power will be then turned off.
21
1 .Introduction
WHAT TO DO
Move to a location within the ser-
vice area or where reception is
better so that the indicator goes
out.
Move closer to the base station.
Move to a location within the ser-
vice area or where reception is
better so that the indicator goes
out. Move closer to the base sta-
tion.
Move to a location where recep-
tion is better.
Cancel the lock phone mode.
See p. 37.
Cancel key guard. See p. 32.
Recharge the battery.

Advertisement

Table of Contents
loading

Table of Contents