Using The Scheduler - UTStarcom UTS708SY Instruction Manual

*SM-801 PHS/sec4(GB) 00.3.9 5:04 PM
4. Convenience features

USING THE SCHEDULER

You can use the Scheduler function to sound a 30-second alarm and display a mes-
sage at a specified time.
• Up to three events per day, and a total of 20 events can be scheduled.
• Schedules can be set up to one month in advance from the date of setting.
• The alarm stops automatically after 30 seconds. Press any key to stop the
alarm manually.
q t
• Pressing either or will clear the message from the display and memo-
ry after 60 seconds.
• The date and time (P35) must be set in order to use the Scheduler function.
Press es4s2
1
or esus[
Presse e and use ] to move the cursor to the mark for the
2
event that you want to schedule, and then press e again.
• To register a new schedule: select space.
• To edit an existing schedule: select the mark that you want to change.
Scheduled events
• Marks for existing scheduled events are displayed.
• Up to three events can be scheduled per day, and they are displayed in order
of occurrence from the left.
• It is not possible to schedule multiple events for the same time.
Input the message and then press e.
3
• If the data already exists, it is displayed.
• The message can be up to 24 characters in length.
<REF>Entering text (P63 to 66)
Page 68
Cursor
• If 20 events have already
been scheduled, the mes-
sage shown on the right is
displayed and you are
returned to step 1.
68
Use ] to select a mark, then press e.
4
(use 0 to 9, = or - for direct selection)
The name for the selected
mark is displayed
• If the data already exists, the selected mark will flash.
• The marks provide a convenient means of distinguishing between events.
Press e, set the time, and then presse again.
5
NOTE
• If a call is in progress when the time for a scheduled event arrives:
The alarm sounds and the message for the scheduled event is displayed when
you finish the call.
• If several schedules are set close together, and call is in progress at the
times set for them:
The schedules are displayed in order of occurrence from the left.
(e.g. if the schedule times are set for 11:00 and 11:01)
• If the power is off:
The schedule is not displayed.
If the set time for a schedule elapses while the power is off, the schedule is
automatically erased on the following day.
• Alarms:
– The alarm volume is as adjusted in the ringer volume (P55).
– If the volume is set to "Off", the alarm does not sound.
– It is possible to set the ringer volume to "OFF" and receive alarm notification
by setting the vibrator to "On" (P53). If the telephone is in the charger unit in
the case of the above setting, the alarm will sound at the "Middle" volume
setting.
• If the date/time is modified after setting a schedule:
Be aware that this can cause schedules to be shifted or erased.
4. Convenience features
69