2.3 Mounting
Installation steps:
Step1:Determination of Installation Location and Heat-dissipation Space
Determination of installation location: The inverter/charger shall be installed in a place with
sufficient air flow through the radiators of the controller and a minimum clearance of 150 mm
from the upper and lower edges of the controller to ensure natural thermal convection. Please
see Figure 2-1: Mounting.
WARNING: Risk of explosion!
Never install the controller with flooded batteries in a sealed enclosure! Do not
install the battery in a confined area where battery gas can accumulate.
Step 2:Take down the terminal protective cover
Figure2-1 Mounting
※Screw off the screws and
take down the terminal
protective cover of the
inverter/charger before
wiring.
6