Table of Contents
Advertisement
Cause:
Solution:
Cause:
Solution:
Cause:
Solution:
Cause:
Solution:
GPIB-488
ENOL—No listening device(s)
The routine detected no listeners.
Verify the following:
•
Make sure that a device has been addressed properly.
•
Check that at least two-thirds of the devices on the GPIB
bus are turned on, including the specified device.
•
Make sure that all connections are secure.
•
Verify the device(s) GPIB address.
•
Make sure that the device was properly configured.
EADR—GPIB interface board not addressed
The GPIB interface board has not been addressed.
Call
and address the board.
ibcmd
If you are calling
.
ibcac
EARG—Invalid argument
An invalid parameter has been provided to a routine.
Check syntax and range of parameters. See Chapter 3,
Library
Reference, and Chapter 4,
ESAC—Board is not the system controller
Routine requires that the GPIB interface board is the system
controller.
Configure the board to be the system controller.
, with shadow handshaking enabled, call
ibgts
GPIB 488.2 Library
C-3
Appendix C
IBERR
GPIB 488.1
Reference.
Programming Reference Manual
Advertisement
Table of Contents
