Table of Contents
Advertisement
Bit
RQS
Device Requesting Service. If this bit = 1, a device is requesting service. RQS
is set in the status word whenever the hex 40 bit is asserted in the serial poll
status byte of the device. The serial poll that obtained the status byte may have
been the result of an
if automatic serial polling is enabled. RQS is cleared when an
serial poll status byte that caused the RQS. An
done on devices that respond to serial polls.
CMPL
I/O Completed. When set, this bit indicates that all I/O operations have been
completed. CMPL is cleared while I/O is in progress.
LOK
Lockout State. Indicates whether the board is in a lockout state. While LOK is
set, the
LOK is set whenever the GPIB board detects the Local Lockout (LLO) message
has been sent either by the GPIB board or another Controller. LOK is cleared
when the Remote Enable (REN) GPIB line becomes unasserted by the system
controller.
REM
Remote State. If this bit = 1, the GPIB Interface Board is in the remote state
(that is, the REN line has been asserted and the Board has been addressed as a
listener.). This bit is cleared when one of the following occurs:
CIC
Controller-In-Charge. If this bit = 1, it indicates that the GPIB Interface Board
is the Active Controller. This bit is set upon the following conditions:
ATN
Attention. If this bit = 1, ATN is asserted. Likewise, if this bit = 0, the ATN line
is unasserted.
GPIB-488
Table B-1. Bit Definitions (Continued)
or the poll may have been automatically performed
ibrsp
routine or
EnableLocal
•
•
•
•
•
•
B-3
Description
ibwait
function is inoperative for that board.
ibloc
REN is unasserted.
The GPIB Interface Board has been addressed as a
Listener and receives a GTL (Go to Local)
command.
is called while the LOK bit = 0.
ibloc
If the board is the system controller and
is executed.
SendIFC
Control is passed to the GPIB Interface Board.
This bit is cleared whenever the GPIB board
detects Interface Clear (IFC) from the system
controller, or when the GPIB board passes control
to another device.
Appendix B
IBSTA
reads the
ibrsp
on RQS should only be
ibsic
Programming Reference Manual
or
Advertisement
Table of Contents
