Port Shaper Policy Support On L2 Fabric Icl Interface - Cisco ASR 9000 Series Configuration Manual

Configuring Modular QoS Service Packet Classification
!
The example shows how to apply the PWHE aggregate shaper on PWHE main interface and another policy
on its subinterface when the LC is in co-existence mode:
• Use the hw-module qos-mode pwhe-aggregate-shaper sub-interface { queuing | non-queuing
Note
• For the following example to work, the LC must be in co-existence queuing mode.
• When LC is in co-existence mode, apply only PWHE aggregate shaper policy on PWHE main
policy-map pwhe-aggregate-shaper
class class-default
shape average 1 gbps
bandwidth remaining ratio 20
!
end-policy-map
!
policy-map pw_parent_out
class class-default
service-policy pw_child_out
shape average 100 mbps
!
end-policy-map
!
interface pw-ether 1
service-policy output pwhe-aggregate-shaper
!
interface pw-ether 1.1
service-policy output pw_parent_out
For other PWHE related information, please refer the Cisco ASR 9000 Series Aggregation Services Router
MPLS Layer 3 VPN Configuration Guide

Port Shaper Policy Support on L2 Fabric ICL Interface

In L2 fabric mode, a port shaper policy can be applied on the inter-chassis link (ICL) sub-interface. The port
shaper policy applied on the ICL sub-interface helps to control the traffic going out on all satellite access
ports, and efficiently handles the oversubscribed backhaul ethernet virtual circuits (EVC). This port shaper
policy applies to all the satellite interfaces hosted under the ICL sub-interface.
Restrictions
• Support to add or remove the port shaper policy is implemented only when the nV satellite configuration
• Only the port shaper policy can be configured under the L2 Fabric ICL in egress direction.
• Ability to shape all satellite ports under a single satellite in a simple ring mode is not supported.
• When operating in L2 fabric and simple ring mode, only upto 2 levels of QoS policies are supported on
} { ingress | egress } command to enable co-existence mode on the LC.
interface.
is present on the ICL sub-interface.
the satellite access ports. The user-defined class configuration is not supported at parent level.
Cisco ASR 9000 Series Aggregation Services Router Modular Quality of Service Configuration Guide, Release 6.1.x
Port Shaper Policy Support on L2 Fabric ICL Interface
127