Configuring QoS on the Satellite System
Class-map with options
Class-map with options
cos (0-7)
ip dscp (0-63)
ip precedence (0-7)
mpls exp topmost (0-7)
QoS Offload Configuration Overview
Three steps to configure QoS Offload are:
1 Create a class-map of the type 'qos'.
2 Create a policy-map of the type 'qos' using the above configured class map.
3 Bind QoS policy to Satellite interfaces such as physical access, bundle access, physical ICL, and bundle
ICL.
To modify a QoS Offload configuration:
1 Modify the class-map or policy-map without unbinding the policy-map from the applied interface.
Note
QoS Offload configuration with police rate in pps unit is not supported.
Sample QoS Offload Configuration
class-map match-any my_class
match dscp 10
end-class-map
!
policy-map my_policy
class my_class
police rate percent 30
!
end-policy-map
!
interface GigabitEthernet100/0/0/9
ipv4 address 10.1.1.1 255.255.255.0
nv
service-policy input my_policy
!
!
Cisco ASR 9000 Series Aggregation Services Router Modular Quality of Service Configuration Guide, Release 6.1.x
QoS Offload Configuration Overview
Maximum Number of Field Programmable (FP) Entries
300
281