Offloading Service-Policy On L2 Fabric Physical Sfl - Cisco ASR 9000 Series Configuration Manual

Offloading Service-policy on L2 Fabric Physical SFL

Command or Action
Step 11
bundle id bundle-id
Example:
RP/0/RSP0/CPU0:router(config-if)# bundle id 2
Step 12 nv
Example:
RP/0/RSP0/CPU0:router(config-if)# nv
Step 13 satellite-fabric-link satellite satellite_id
Example:
RP/0/RSP0/CPU0:router(config-if)#
satellite-fabric-link satellite 100
Step 14 remote-portsinterface_type remote_subslot
Example:
RP/0/RSP0/CPU0:router(config-satellite-fabric-link)#
remote-ports GigabitEthernet 0/0/0-5
Step 15 service-policy output policy-map
Example:
RP/0/RSP0/CPU0:router(config-satellite-fabric-link)#
service-policy output policy4
Step 16
commit
Step 17
exit
Example:
RP/0/RSP0/CPU0:router(config-if)# exit
Step 18 commit
Offloading Service-policy on L2 Fabric Physical SFL
Perform these tasks to offload the service-policy on L2 Fabric physical Satellite Fabric Link (SFL). This
procedure offloads the service-policy in the egress direction of SFL.
Cisco ASR 9000 Series Aggregation Services Router Modular Quality of Service Configuration Guide, Release
6.1.x
292
Configuring QoS on the Satellite System
Purpose
Creates a multilink interface bundle with the specified
bundle ID.
Enters the satellite network virtualization (nV)
configuration submode.
Specifies an interface as an Interface Control Plane
Extender(ICPE) inter-chassis link (ICL).
The Interface Control Plane Extender(ICPE)
Note
infrastructure has a mechanism to provide the
Control Plane of an interface physically
located on the Satellite device in the local
Cisco IOS XR software.
Configures the remote satellite ports 0 to 5.
Attaches a policy map to an output interface to be used
as the service policy for that interface.
Returns the router to global configuration mode.